Software Distributor Administration Guide for HP-UX 11i

Managing Installed Software
Listing Your Software (swlist)
Chapter 3102
Changing
Command Options
You can change the behavior of this command by specifying additional
command-line options when you invoke the command (using the -x
option) or by reading predefined values from a file. The following table
shows the defaults and options that apply to swinstall.
For More
Information
See Appendix A, “Command Options,” on page 421 for complete
descriptions of each default.
Table 3-3 swlist Command Options and Default Values
• admin_directory=/var/adm/sw
• agent_timeout_minutes=10000
• codeword=
•customer_id=
• distribution_target_directory=
/var/spool/sw
• installed_software_catalog=
products
• layout_version=1.0
• level=
• log_msgid=1
• one_liner=revision title
• patch_one_liner=title
patch_state
• rpc_binding_info=
ncacn_ip_tcp:[2121]
ncadg_ip_udp:[2121]
•rpc_timeout=5
• run_as_superuser=true
• select_local=true
• show_superseded_patches=fals
e
•software=
• software_view=all_bundles
•targets=
•verbose=1