Read Before Installing or Updating To HP-UX 11i v1, September 2003

Note

Be sure to verify that your system has the minimum required

firmware version. See the "Firmware Upgrades" section in the

HP-

UX 11i Version 1 Installation and Update Guide

for September

2003 for details and the

PDC Firmware and Boot Support Matrix

paper at the following web site:

http://software.hp.com/SUPPORT_PLUS/info.html

Select the link under "System Firmware Information."

"No Network Interfaces Configured" Warning During

Cold-Install

After cold-installing the September 2003 HP-UX 11i v1 TCOE,

the following warning messages may appear in the

swagent.log

WARNING: There are no network interfaces configured at this time.

The default networking parameters cannot be configured

for this Ignite-UX server. Please use the instl_adm(1M)

command to set the server's IP address (-t), netmask(-m)

and default gateway (-g) as desired. You may instead,

re-run this configure script after networking is

configured using the command:

"/usr/sbin/swconfig -xreconfigure=true Ignite-UX.BOOT-KERNEL"

WARNING: The "configure" script for "Ignite-UX.BOOT-KERNEL-PA"

had a warning (exit code "2"). The script location was

"/var/adm/sw/products/Ignite-UX/BOOT-KERNEL-PA/config

ure".

* This script had warnings but the execution of