Managing Systems and Workgroups: A Guide for HP-UX System Administrators

Planning a Workgroup
Planning your Printer Configuration
Chapter 2122
NOTE For further information about these values, consult the section,
“Automatically Starting HPDPS,” in Chapter 4, “Getting Started with
HPDPS”. You can read /etc/rc.config.d/pd to familiarize yourself
with the values you need to set.
DCE and HPDPS
Extended
Environment
If you intend to take fuller advantage of HPDPS functionality and
configure an HPDPS Extended Environment, you must also install DCE
filesets. Note, the DCE filesets required to run an HPDPS Extended
Environment are not those that are bundled with the HP-UX core
filesets. They are part of an optional HP product.
PDPRNPATH Defines the paths where HPDPS finds
printer model files. (For information on the
contents of a model file directory, see the HP
Distributed Print Service Administration
Guide.)
PD_CLIENT Specifies whether the host system starts a
client daemon. Set by default to
PD_CLIENT=0, meaning the host does not
start a client. (Set PD_CLIENT=1 to start a
client daemon automatically during reboot.)
PD_SPOOLERS Defines the spooler names to start and
execute on this host. No spoolers are started
by default; follow the instructions given in
the file to start spoolers.
PD_SUPERVISORS Defines the supervisor names to start and
execute on this host. No supervisors are
started by default; follow the instructions
given in the file to start supervisors
PD_MEMLIMIT Defines the maximum amount of memory (in
kilobytes) the spooler or supervisor can use
on the host system
Table 2-7 Values stored in the /etc/rc.config.d/pd file (Continued)
Value Definition