Managing Superdome Complexes: A Guide for HP-UX System Administrators

Conﬁguring and Managing Superdome Partitions

HP-UX Superdome Conﬁguration Commands—Details and Syntax

Chapter 4208

HP-UX Superdome Conﬁguration

Commands—Details and Syntax

This section provides you with additional details and the command-line

syntax for the new HP-UX Superdome conﬁguration commands.

The following HP-UX commands are covered here:

• parcreate Command

• parmodify Command

• parremove Command

• parstatus Command

• parunlock Command

For a general introduction to using these commands, see “HP-UX

Superdome Conﬁguration Commands—An Introduction” on page 135.

NOTE The command information provided on the following pages is provided

for quick reference. These are not the manpages. Please consult the

corresponding manpages on your system for the most up-to-date

information on the syntax and options for these commands, information

which could have changed since this manual was published.