Managing Superdome Complexes: A Guide for HP-UX System Administrators

Conﬁguring and Managing Superdome Partitions

Procedures for Managing Partitions

Chapter 4 155

Step 7. Conﬁrm that the Genesis Partition was successfully created.

If the Genesis Partition is successfully created, the CC command reports

that the “complex proﬁle will be modiﬁed”.

When the Genesis Partition is created, it is in a boot-is-blocked state, so

must be booted manually.

Step 8. Issue the BO command to boot the Genesis Partition.

This boots the partition to the Boot Console Handler (BCH) interface.

Step 9. Conﬁgure the partition as appropriate and necessary.

You may wish to set the boot paths (PRI, ALT, and HAA), the core cell

preferences, the partition name, and other settings. You also may need to

add cells to the partition.

See “Introduction to Partition Tasks” on page 114 for a table of partition

conﬁguration tasks that you can perform.

GSP:CM> BO

# Name

--- ----

0) Partition 0

Select a protection domain number : 0

Do you want to boot Protection Domain number 0,

named Partition 0 ? (Y/[N]) y

-> The selected Protection Domain will be booted.

GSP:CM>