HP-UX HB v13.00 Ch-21 - Itanium

HP-UX Handbook – Rev 13.00 Page 21 (of 35)
Chapter 21 Itanium Architecture (IA)
October 29, 2013
SIZE: Text:19787K + Data:2610K + BSS:2381K = Total:24779K
If you are sitting in front of the VGA monitor and your system seems to hang at this stage the
console output may not be configured properly. The “SIZE:” message above is printed by HP-
UX bootloader who prints console output to all available devices. The subsequent message
“Console is on ...” is printed by the HP-UX kernel’s funtion printf(). This goes only to
the configured console path. Refer to the section above in order to configure the console for
VGA.
If boot messages are set up to be directed to your current console device, the boot processes will
continue as follows:
Console is on a Serial Device
Booting kernel...
Here it takes some time, then the normal boot process as described in the Boot chapter continues
until you get the Console login:
Loaded ACPI revision 2.0 tables.
NOTICE: nfs3_link(): File system was registered at index 4.
NOTICE: autofs_link(): File system was registered at index 5.
NOTICE: cachefs_link(): File system was registered at index 6.
td: claimed Tachyon XL2 Fibre Channel Mass Storage card at 0/7/1/0
Boot device's HP-UX HW path is: 0.0.2.0.2.0
legacyio_cdio_end: WARNING isc for function 0 not found!!!
System Console is on the Built-In Serial Interface
igelan0: APA NOT SUPPORTED on HP A6794-60001 PCI 1000Base-T at hardware path
0/1/1/0/4/0
igelan0: INITIALIZING HP A6794-60001 PCI 1000Base-T at hardware path 0/1/1/0/4/0
Entering cifs_init...
Initialization finished successfully... slot is 10
Logical volume 64, 0x3 configured as ROOT
Logical volume 64, 0x2 configured as SWAP
Logical volume 64, 0x2 configured as DUMP
Swap device table: (start & size given in 512-byte blocks)
entry 0 - major is 64, minor is 0x2; start = 0, size = 8388608
Starting the STREAMS daemons-phase 1
Checking root file system.
file system is clean - log replay is not required
Root check done.
....... OK
...
...
...
...
The system is ready.
GenericSysName [HP Release B.11.22] (see /etc/issue)
Console Login: