HP-UX HB v13.00 Ch-21 - Itanium

HP-UX Handbook – Rev 13.00 Page 13 (of 35)
Chapter 21 Itanium Architecture (IA)
October 29, 2013
 Management port Lan (lan console)
 Management port Serial
NOTE: the Management Port (MP) is only available on servers, not on workstations.
From the EFI Boot Maintenace Manager menu you can enable or disable these ports:
EFI Boot Maintenance Manager ver 1.10 [14.61]
Main Menu. Select an Operation
Boot from a File
Add a Boot Option
Delete Boot Option(s)
Change Boot Order
Manage BootNext setting
Set Auto Boot TimeOut
Select Active Console Output Devices _
Select Active Console Input Devices _
Select Active Standard Error Devices
Cold Reset
Exit
In this example all three devices are enabled. The asterix indicates this.
Select the Console Output Device(s)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100)
* Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(VtUtf8)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100)
* Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(VtUtf8)
* Acpi(HWP0002,700)/Pci(2|0)
Save Settings to NVRAM
Exit
Use the following table to identify the different ports:
Console Port
UART
PCI
VGA
no
yes
MP Lan
no
yes
MP Serial
yes
yes
System Serial
yes
no
UART = Univeral Asynchronous Receiver-Transmitter
system
serial
MP serial
VGA or
MP lan