HP-UX HB v13.00 Ch-19 - PRM

HP-UX Handbook – Rev 13.00 Page 7 (of 31)
Chapter 19 Process Resource Manager (PRM)
October 29, 2013
NOTE: If the PRM-Sw-Krn.PRM-KRN fileset is not installed or it is installed but its revision is
older than the current revision, the current revision will be installed, causing a reboot.
PRM Release History
11.11
11.23
11.22
11.31
End of
Support
C.02.00.04

Sep 05
C.03.00


Jul 09
C.03.01


Jun 10
C.03.02


Mar 11
C.03.02.02

Feb 11
C.03.03.01



Mar 12
C.03.04



*
C.03.05



*
C.03.05.01


*
For a list of recommended patches consult the Release Notes and http://www.hp.com/go/prm
(select the “Patches and Support” link at the bottom of the web site).
Pre-Installation Steps
Consult the Release Notes for detailed installation instructions. Before installing the PRM
product:
1. Shut down any versions of PRM, WLM, and GlancePlus that are already installed.
Having these products running can prevent the proper update of files that are in use. Be
sure to shut down WLM (wlmd -k), its configuration wizard, wlmgui, PRM (prmconfig -
r), xprm, and GlancePlus - if any of them are running.
2. Evaluate whether to upgrade any WLM version that is installed (see release notes for
details).
3. Shut down MeasureWare if it is running:
# /sbin/init.d/mwa stop
4. Shut down HP Integrity Virtual Machines if it is running:
# /sbin/init.d/hpvm stop
PRM cannot run on a host used as a VM Host. However, you can use PRM inside virtual
machines.