HP-UX HB v13.00 Ch-17 - vPars

HP-UX Handbook – Rev 13.00 Page 30 (of 46)
Chapter 17 Virtual Partitions (vPars)
October 29, 2013
scan
Lists all hardware discovered by the Monitor and indicates which virtual partition owns each
device.
toddriftreset
Reset the drifts of the real-time clock. Use this command if you reset the real-time clock of the
hard partition at the BCH prompt.
vparinfo
vparinfo [partition_name]
This command is for HP internal use only.
-a all entries
-l long listing
-n numerical UIDs and GIDs
-i inode
-F appends a character after the entry; depending on the file type, such as a / (slash) for a
directory when no partition name is given, vparinfo displays all unassigned resources and
the names of all existing virtual partitions; when partition_name is given, vparinfo
displays the resources assigned to partition_name.
monadmin
monadmin [-S on|off] | [-a|-d partition_name] | [-l]
This command is used with flexible vPars administrative capability to:
 Enable or disable this admin capability;
 list the designated-admin virtual partitions;
 add or delete a vPars from that list.
This capability is being set to off by default.
vPars Commands
Command
Explanation