HP-UX HB v13.00 Ch-16 - iCAP

HP-UX Handbook – Rev 13.00 Page 8 (of 24)
Chapter 16 Instant Capacity (iCAP)
October 29, 2013
HP OpenView measurement products, such as MeasureWare and GlancePlus, must be version
C.02.60 or later to provide correct measurements. Earlier versions of the OpenView
measurement products might not work correctly on Instant Capacity systems.
Installing/Updating the iCAP Software
The following brief overview lists the steps for the installation and configuration of an iCAP
system. Consult the official documentation for a full description.
The Instant Capacity software is installed by HP on all HP enterprise factory integrated servers,
even those without Instant Capacity components. The Instant Capacity software is automatically
installed when the HP-UX 11i v1, 11i v2, or 11i v3 Operating Environment (OE) is installed.
To verify the Instant Capacity software is installed on your system, execute the following HP-
UX command:
# /usr/sbin/swlist -l product iCOD
Output similar to the following is displayed:
iCOD B.11.31.10.03.00.06 Instant Capacity
To verify that the Instant Capacity software installation has not been corrupted, execute the
following HP-UX command:
# /usr/sbin/swverify iCOD
The command will display the message “Verification succeeded”.
If you do need to install the Instant Capacity software, it is available from the following
media/location:
 HP software depot at http://www.hp.com/go/softwaredepot
 HP-UX 11i v3 Operating Environments (OE) media
 HP-UX 11i v2 Applications Software media
 HP-UX 11i v1 Applications Software media
After you have successfully installed the Instant Capacity software using the swinstall command,
perform the following procedure to validate your installation: