HP-UX HB v13.00 Ch-16 - iCAP

HP-UX Handbook – Rev 13.00 Page 7 (of 24)
Chapter 16 Instant Capacity (iCAP)
October 29, 2013
Software requirements HP-UX 11.23
 HP-UX 11i v2
 iCAP software bundle B9073BA (version 10.x)
 The kernel configuration must include the diag2 module.
 WBEM B8465BA bundle (version A.02.05 or higher)
 nParProvider bundle (version B.23.01.06.02 or higher, available from the OE media)
 If you have a virtual partitioned environment, the Virtual Partitions (vPars) software
(bundle T1335BC) must be version A.04.01 or higher. vPars is available separately and is
not included with the OE.
 (GiCAP only) The CIM Server configuration property sslClientVerificationMode must
be set to a value of “optional” on all GiCAP Group Managers and on all OS instances of
all member systems.
NOTE: On HP-UX 11i v2 systems, updated firmware might be required by the nPar or Virtual
Partition software, as documented for these products.
 Patches:
PHKL_33752: S700_800 11.23 Itanium 2 Processor speed reporting patch
(required only for IA systems)
PHCO_34721: killall(1M) patch
PHKL_35174: _CS_PARTITION_IDENT patch
(required for GiCAP on rx8640 and rx7640 systems)
For the most recent required patches, see the Instant Capacity Installation page on the HP
Software Depot (search for “B9073BA”).
Software requirements HP-UX 11.31
 HP-UX 11i v3
 iCAP software bundle B9073BA (version10.x)
 The kernel configuration must include the diag2 module.
 WBEMSvcs bundle (version A.02.05 or higher)
 nParProvider bundle (version B.31.01.07.01 or higher, available from the OE
media)
 If you have a virtual partitioned environment, the Virtual Partitions (vPars)
software (bundle T1335BC) must be version A.05.01 or higher. vPars is available
separately and is not included with the OE.
 (GiCAP only) The CIM Server configuration property sslClientVerificationMode
must be set to a value of “optional” on all GiCAP Group Managers and on all OS
instances of all member systems.
 For Instant Capacity Version 10.00 and later, on HP–UX 11i v3 HP Integrity
systems, patch PHCO_40927 must be installed. This is a co-requisite.