HP-UX HB v13.00 Ch-15 - Serviceguard

HP-UX Handbook – Rev 13.00 Page 83 (of 108)
Chapter 15 Serviceguard
October 29, 2013
Serviceguard Command Problems
Sometimes Serviceguard commands fail and log messages that indicate that either the node is not
configured into the cluster, that the binary configuration file misses or other basic problems. The
commands that are usually affected by this are:
cmapplyconf
cmcheckconf
cmcp
cmdeleteconf
cmexec
cmgetconf
cmhaltcl
cmhaltnode
cmhaltpkg
cmmodpkg
cmquerycl
cmruncl
cmrunnode
cmrunpkg
cmviewcl
cmviewconf
Symptoms
Typical examples:
# cmviewcl
cmviewcl : Cannot view the cluster configuration.
Either this node is not configured in a cluster, user doesn't have
access to view the cluster configuration, or there is some obstacle
to viewing the configuration. Check the syslog file for more information.
For a list of possible causes, see the Serviceguard manual for cmviewcl.
# cmviewconf
cmviewconf: Unable to get cluster configuration information.
Unable to open communications to configuration daemon: Connection refused
Unable to connect to configuration database.
# cmviewconf
cmviewconf: Either binary file does not exist, or the user doesn't
have access to view the cluster configuration.
# cmhaltpkg pkgA
cmhaltpkg : Unable to open handle to local cluster
Either no cluster configuration file exists, the file is corrupted,
cmclconfd is unable to run, or user root on node nero
doesn't have access to view the configuration.
# cmviewcl