HP-UX HB v13.00 Ch-15 - Serviceguard

HP-UX Handbook – Rev 13.00 Page 52 (of 108)
Chapter 15 Serviceguard
October 29, 2013
With the advent of a new cluster manager engine in A.11.18, Serviceguard daemons and
commands offer different debug logging mechanisms. The following is taken from this WTEC
page:
http://teams3.sharepoint.hp.com/teams/esssupport/InsideESSSupport/InsideWTEC/HAProducts/Pages/s
g_debug_logging.aspx
Debug logging of cmcld (SG A.11.19 and later)
From SG A.11.19 onwards you can start logging for cmcld by adding the following lines in
the /etc/cmcluster.conf and do a kill -SIGHUP <pid>.
CMCLD_LOG_FILE=/var/adm/cmcluster/cmcld.log
CMCLD_LOG_LEVEL=6
You can also enable debug logging for a specific module only by setting in the same file:
CMCLD_{module mnemonic}_LOG_LEVEL=6
Ex: For the Utility Daemon use CMCLD_UTL_LOG_LEVEL
where {module mnemonic} is one of the following:
ATN = Auto Trans
CDB = Configuration Database
CLM = Cluster Management
CMD = Commands
CML = SAF Distributed Lock Service
CMP = Config/Status Proxy
CMS = SAF Cluster Membership Service
CNF = Configuration
COM = Communication Server
CSV = Command Server
DFA = Disk File Access
DLK = Disk Lock
DLM = Distributed Lock Management
EVT = Cluster Management Event
GMD = Group Membership Server
GMS = Group Membership Service
LOC = Local Communication
LVM = Logical Volume Management
MDV = Module Version
MSG = Messaging
NET = Network Management
PKG = Package Management
PLE = Placement Engine
QSM = Quorum Service
REM = Remote Communication
RES = EMS Resources