HP-UX HB v13.00 Ch-15 - Serviceguard

HP-UX Handbook – Rev 13.00 Page 30 (of 108)
Chapter 15 Serviceguard
October 29, 2013
Found 2 volume groups on node Node2
Analysis of 5 volume groups should take approximately 1 seconds
0%----10%----20%----30%----40%----50%----60%----70%----80%----90%----100%
Note: Disks were discovered which are not in use by either LVM or VxVM.
Use pvcreate(1M) to initialize a disk for LVM or,
use vxdiskadm(1M) to initialize a disk for VxVM.
Gathering network information
Beginning network probing
Completed network probing
Node Names: Node1
Node2
Bridged networks (local node information only - full probing was not
performed):
...
IP subnets:
IPv4:
...
IPv6:
Possible Heartbeat IPs:
...
Possible Cluster Lock Devices:
...
LVM volume groups:
LVM physical volumes:
...
LVM logical volumes:
...
Writing cluster data to /tmp/cluster.ascii.
The above cmquerycl command presupposes that the cluster arbitration device is a lock VG that
is shared by both nodes and is registered in /etc/lvmtab on both nodes and that both nodes have
NICs assigned IPs on the same subnet. The resulting output is cluster.ascii, which contains
cluster-specific configuration information.
Required parameters:
CLUSTER_NAME rxh17u09_cluster
HOSTNAME_ADDRESS_FAMILY IPV4
MEMBER_TIMEOUT 14000000 <- default
AUTO_START_TIMEOUT 600000000 <- default
NETWORK_POLLING_INTERVAL 2000000 <- default
NETWORK_FAILURE_DETECTION INOUT <- default
NETWORK_AUTO_FAILBACK YES <- default
MAX_CONFIGURED_PACKAGES 300 <- default