HP-UX HB v13.00 Ch-06 - Ignite-UX

HP-UX Handbook – Rev 13.00 Page 47 (of 58)
Chapter 06 Ignite-UX
October 29, 2013
Booting Integrity and PA-RISC Clients from the Network
Note: For booting older workstations please see the Ignite-UX Admin Guide at
www.hp.com/go/ignite-ux-docs
1) Switch the client on and interrupt the boot sequence pressing any key.
2) Boot from the Ignite-UX server or boothelper using one of these ways:
a) PA-RISC: If your network only has one Ignite-UX server available, enter:
BOOT ADMIN> boot lan install
Integrity: If the network only has one Ignite-UX server available, enter:
EFI shell> lanboot select
b) PA-RISC: To boot from a specific Ignite-UX server, enter:
BOOT ADMIN> boot lan.15.10.18.156 install
where 15.10.18.156 is the IP of the Ignite-UX server.
Integrity: Use the EFI Shell dbprofile command to first create a ip profile.
Shell> dbprofile [ -dn name [ -dhcp ] [ -sip server_ip ] [ -cip client_ip ]
[- gip gateway_ip ] [ -m subnet_mask ] [ -b "boot_file" ]
[ -od "optional_data" ]] | [ -h ]
dbprofile [ rm name ] | [ -h ]
dbprofile [ cp src_name dst_name ] | [ -h ]
Example:
Shell> dbprofile -dn testprofile -sip 192.1.2.1 -cip \
192.1.1.20 -gip 192.1.1.1 -m 255.255.255.0 -b \
"/opt/ignite/boot/nbp.efi"
PA-RISC: If the client is not in the same subnet as the Ignite-UX server, direct the installation to a boot
helper: