HP-UX HB v13.00 Ch-06 - Ignite-UX

HP-UX Handbook – Rev 13.00 Page 28 (of 58)
Chapter 06 Ignite-UX
October 29, 2013
# /usr/bin/mt -t /dev/rmt/0mn rew
# /usr/bin/mt -t /dev/rmt/0mn fsf 1
# /usr/bin/tar tvf /dev/rmt/0m Note: 0m not 0mn
Extracting single files from the tar archive (Integrity)
# /usr/bin/mt -t /dev/rmt/0mn rew
# /usr/bin/mt -t /dev/rmt/0mn fsf 22
# /usr/bin/tar xvf /dev/rmt/0m filename1 tmp/filename2
Note there is no leading ‘/‘ when specifying a directory path.
Extracting single files from the tar archive (PA-RISC)
# /usr/bin/mt -t /dev/rmt/0mn rew
# /usr/bin/mt -t /dev/rmt/0mn fsf 1
# /usr/bin/tar xvf /dev/rmt/0m filename1 tmp/filename2
Note there is no leading ‘/‘ when specifying a directory path.
Restoring from a make_tape_recovery Tape
automatically
1. Insert the System Recovery tape into the tape drive.
2. Boot the system.
3. Interrupt the boot sequence to redirect it to the tape drive.
4. Allow the install process to complete automatically.
interactive mode (changing system configuration, cloning)
1. Insert the System Recovery tape into the tape drive.
2. Boot the system.
3. Interrupt the boot sequence to redirect it to the tape drive.
4. Cancel the non-interactive installation by hitting the <Return> key when the
following messages are displayed:
5. WARNING: The configuration information calls for a non- interactive installation.
Press <Return> within 10 seconds to cancel batch-mode installation:
The "Ignite-UX Welcome" screen will be presented. Select the option: [ Install HP-
UX ]
6. Then select the option: [ ] Advanced Installation