HP-UX 11i Version 1.6 Installation and Configuration Guide

Preparing for Cold Install
Updating Your Ignite-UX Server
Chapter 248
Updating Your Ignite-UX Server
The HP-UX 11i v1.6 DVD contains the complete Ignite-UX product.
When you cold-install HP-UX 11i v1.6 from the media, a subset of
Ignite-UX is used to perform the installation on a single system.
If you plan to update an existing Ignite-UX server to install HP-UX 11i
v1.6 on more than one system in your network, then you should update
your Ignite-UX server first.
Updating your Ignite-UX server and using it to update other systems
will ensure that you have the make_net_recovery command to backup
and recover your systems (see the make_net_recovery (1M) manpage for
information). You will also be assured of keeping consistent kernel
configuration with specific drivers, daemons, and kernel tunables on all
systems.
The latest Ignite-UX software and documentation can also be
downloaded from HP via this web site:
http://software.hp.com/products/IUX
NOTE You cannot use make_tape_recovery and make_recover with HP-UX
11i v1.6. The make_net_recovery command is available.