HP-UX 11i Version 1.6 Installation and Configuration Guide

Welcome to HP-UX 11i v1.6
Features and Applications Available in HP-UX 11i v1.6
Chapter 118
NOTE HP is continually adding support for additional hardware and software.
Contact your HP Service Representative for information about
additional support or refer to the latest edition of this document on
http://docs.hp.com.
Features Unavailable in HP-UX 11i v1.6
In comparison with HP-UX 11i, HP-UX 11i v1.6 does not provide support
for the following:
• PA-RISC systems
• Operating system update (Update-UX), HP-UX 11i v1.6 must be cold
installed
• HP-UX Workload Manager
• Virtual Partitions (vPars)
• Business Copy/BCV/snapshot features on high-end disk arrays
• Fabric connectivity with Fibre Channel Mass Storage
• OSPF agent for gated
• PA-RISC cross development on Itanium-based processors
• HP-supplied PA-RISC mode archive system libraries
• HP-supplied Itanium-based archived system libraries
• Mix & match between Itanium-based and PA-RISC binaries and/or
32-bit and 64-bit objects
• Framebuffer graphics support
• Boot from floppy disk
• I/O OLAR/D
• CCNuma
• Veritas Volume Manager version 3.2
• Instant Capacity on Demand (iCOD)
• make_tape_recovery
In addition, administrators and developers should make note of the
following important changes and limitations:
• No 32-bit version of this OS will be made available.
• The id number returned by uname may no longer be unique.