HP-UX 11i Version 1.6 Installation and Configuration Guide

Known Problems and Troubleshooting
Common Install Error and Warning Messages
Appendix B104
SW-GETTOOLS software selections not available
One or more warning messages may be placed in the file:
/var/adm/sw/swconfig.log during the configure (swconfig) phase of the
installation.
WARNING: The software specification "HPUXBaseAux" refers to a
bundle (or to a product, subproduct or fileset within a
bundle). Only some of the software specified could be selected.
The messages below show those items which could not be selected
and those items which were selected but generated a warning:
* Could not apply the software selection
"SW-GETTOOLS.PRE-UPDATE,r=B.11.22,a=HP-UX_B.11.22_IA/PA,v=HP";
it is not available from depot or root "gold15:/".
* Could not apply the software selection
"SW-GETTOOLS.SD-SUPPORT,r=B.11.22,a=HP-UX_B.11.22_IA/PA,v=HP";
it is not available from depot or root "gold15:/".
* Could not apply the software selection
"SW-GETTOOLS.SD2-SUPPORT,r=B.11.22,a=HP-UX_B.11.22_IA/PA,v=HP"
; it is not available from depot or root "gold15:/".
SW-GETTOOLS product is installed as part of the update toolset, which
is not supported in HP-UX 11i Version 1.6 (B.11.22). During a cold
install, this product is not selected for installation, which results in this
warning message.
This message is strictly informational and no action is required.
Obsolete Product Warnings
One or more warning messages may be placed in the file:
/var/adm/sw/swconfig.log during the configure (swconfig) phase of the
installation.
WARNING: The software specification "HPUXBaseOS" refers to a
bundle (or to a product, subproduct or fileset within a
bundle). Only some of the software specified could be selected.
The messages below show those items which could not be selected
and those items which were selected but generated a warning:
* Could not apply the software selection