HP-UX 11i Version 1.6 Installation and Configuration Guide

Known Problems and Troubleshooting
Common Install Error and Warning Messages
Appendix B 103
This message is strictly informational and no action is required.
OpenGLDevKit.OPENGL-xxx Warning
One or more warning messages may be placed in the file:
/var/adm/sw/swconfig.log during the configure (swconfig) phase of the
installation.
WARNING: The software specification "HPUX11i-TCOE" refers to a
bundle (or to a product, subproduct or fileset within a
bundle). Only some of the software specified could be selected.
The messages below show those items which could not be selected
and those items which were selected but generated a warning:
* Could not apply the software selection
"OpenGLDevKit.OPENGL-64-CTRB,r=B.11.22.01,a=HP-UX_B.11.22_PA,v
=HP";it is not available from depot or root "gold15:/".
* Could not apply the software selection
"OpenGLDevKit.OPENGL-64-EXPL,r=B.11.22.01,a=HP-UX_B.11.22_PA,v
=HP";it is not available from depot or root "gold15:/".
...
OpenGLDevKit was not selected for installation because it is a PA-RISC
only product and will not install on an Itanium-based system. Since it
was not selected for installation but is part of the HPUX11i-MTOE and
HPUX11i-TCOE bundle, the selection of products at configure (swconfig)
time produces this warning. Multiple instances of the second part of this
message may occur, each referencing different software selections
beginning with OpenGLDevKit.OPENGL.
This message is strictly informational and no action is required.