HP-UX 11i Version 1 Installation and Update Guide, September 2003

Known Problems and Troubleshooting
Common Install and Update Error and Warning Messages
Appendix B180
this fileset will still proceed. Check the above output
from the script for further details.
What To Do Run the following command to configure your network interfaces:
/usr/sbin/swconfig -xreconfigure=true
Ignite-UX.BOOT-KERNEL-PA
Using Ignite-UX with HP-UX 11i v1 OEs and Patch
Bundles
In order for Ignite-UX to properly load patch bundles, the configuration
file for the install depot needs to be modified. The sd_software_list
definition needs to be removed from the bundle definitions for all patch
bundles in the depot. It is important that all the patch bundles in the
configuration file are modified to allow for patch supersession to work
properly.
The following patch bundles are supported for installation with the
desired HP-UX 11i v1 OE from a single depot source:
BUNDLE11i
HWEnable11i
FEATURE11-11
GOLDAPPS11i
GOLDBASE11i
If you have added any custom patch bundles to your install depot, the
sd_software_list definition for those bundles should be removed also.
With the sd_software_list definition removed, SD will use
autoselect_patches to resolve which patches should be installed.
Figure B-1 Example patch bundle definition from Ignite-UX configuration
file
sw_sel "HWEnable11i" {
description = "Hardware Enablement Patches for HP-UX 11i,
March 2003"
sw_source = "core"
sw_category = "HPUXAdditions"
sd_software_list =
"HWEnable11i,r=B.11.11.0303.4,a=HP-UX_B.11.11_32/64,v=HP"
(_hp_os_bitness == "32") {
impacts = "/sbin" 2016Kb
impacts = "/var" 110304Kb