HP-UX 11i Version 1 Installation and Update Guide, September 2003

Known Problems and Troubleshooting
Common Install and Update Error and Warning Messages
Appendix B 179
Common Install and Update Error and
Warning Messages
As an install or update progresses, you will see messages relating to the
progress being entered into the log file. These messages usually refer to
normal behavior. ERROR and WARNING messages, however, have the
following significance:
ERROR Indicates a serious problem, usually requiring action
from the user in order to proceed with an installation.
WARNING Indicates something out of the ordinary and may
require action.
If you see a message or experience unusual behavior, see the following
pages for likely solutions.
This section includes some update-ux error messages and typical
recovery actions.
“No Network Interfaces Configured” Warning During
Cold-Install
After cold-installing HP-UX 11i v1 TCOE, the following warning
messages may appear in the swagent.log
WARNING: There are no network interfaces configured at this
time.
The default networking parameters cannot be configured
for this Ignite-UX server. Please use the
instl_adm(1M)
command to set the server's IP address (-t),
netmask(-m)
and default gateway (-g) as desired. You may instead,
re-run this configure script after networking is
configured using the command:
"/usr/sbin/swconfig -xreconfigure=true
Ignite-UX.BOOT-KERNEL"
WARNING: The "configure" script for "Ignite-UX.BOOT-KERNEL-PA"
had a warning (exit code "2"). The script location was
"/var/adm/sw/products/Ignite-UX/BOOT-KERNEL-PA/config
ure".
* This script had warnings but the execution of