HP-UX 11i Version 1 Installation and Update Guide, September 2003

Known Problems and Troubleshooting
Known Problems Discovered in this Release
Appendix B 165
DMI/SCR Become Unbundled After Update
After updating to the September 2003 release of HP-UX 11i v1, you may
encounter a warning after running the swlist command indicating that
DMI/SCR (B6816AA) was unbundled during the update:
#
# Product(s) not contained in a Bundle:
#
DMI B.11.11.30 Desktop
Management Interface for HP-UX
SCR B.11.11.30 System
Configuration Repository
How Do You Know
If This Affects
You?
You will encounter this warning if DMI/SCR (B6816AA) was installed
prior to updating.
What To Do DMI/SCR will continue to work after the update. If you plan to continue
using DMI/SCR, HP recommends that you download the latest version of
DMI from http://software.hp.com. Starting with the September 2003
release, DMI will no longer be shipped as part of the operating
environments. Instead, it will be available and supported as a web-only
product.
Unsupported Upgrade of ServiceControl Manager
Causes SCR Error During Update
While updating a 10.20 system to either the Foundation, Enterprise or
Mission Critical operating environment, you may encounter the
following error messages in swagent.log appearing to affect SCR:
ERROR: [300076] Cannot delete the definition for product "SCR" from
the target "/". The product is not empty, it still contains
filesets.
ERROR: [300076] Cannot delete the definition for product "SCR" from
the target "/". The product is not empty, it still contains
filesets.
These error messages are caused by an unsupported upgrade of
ServiceControl Manager 3.0 from a version of SCM earlier than version
2.5. SCM 3.0 only supports upgrades from version 2.5 or higher.