HP-UX 11i Version 1 Installation and Update Guide, June 2004

Installing and Updating System Requirements
Disk Space and Memory Requirements
Chapter 3 67
Step 6. After the system reboots, view swap information by entering:
swapinfo
Kb Kb Kb PCT START/ Kb
TYPE AVAIL USED FREE USED LIMIT RESERVE PRI NAME
dev 307200 45936 216208 0% 0 - 1 /dev/vg00/swap
reserve - 113748 -113748
memory 85584 23492 62092 27%
Step 7. To verify that the same configuration exists as before the reboot, enter
(again):
lvlnboot -v
Step 8. As root, use sam to remove the old lvol2 entry from /dev/vg00.
Step 9. Using sam, increase /stand to the required new size. Also change the
size of any other volumes as needed.
Step 10. Define your new volume as the boot volume at the next reboot:
lvlnboot -b lvol1 /dev/vg00
Step 11. Reboot your system again.
Return to Chapter 2 to update your system to HP-UX 11i v1 using the
update-ux command.