HP-UX 11i Version 1 Installation and Update Guide, June 2004

Installing and Updating System Requirements
Firmware Requirements
Chapter 3 55
IMPORTANT OL* functionality is only supported on HP-UX 11i v1 for servers and PCI
I/O adapters meeting the OLA/R support requirements. The following
patches are required to support OLA/R with SCSI Ultra160 adapters on
HP-UX 11i v1 servers:
PHCO_25831
PHKL_25712 (or later)
For a more complete list of systems that support OL*, go to the following
web site:
http://docs.hp.com
and search for “Interface Card OL* Support Matrix”
PCI Adapter Requirements
Before installing HP-UX 11i v1, be sure to replace any HP A3740A PCI
adapters in your system with A5158A PCI Tachyon TL adapters. The
A3740A PCI adapter is not supported on HP-UX 11i v1. Connect any
fibre channel mass storage devices previously connected to A3740A to
the A5158A adapters.
Current System Firmware Versions and Patches
In addition to verifying that your system meets the minimum
requirements to support HP-UX 11i v1 in Table 3-2, the following table
describes the latest recommended firmware versions available for your
system. These patches contain additional enhancements and fixes to
your system and also support HP-UX 11i v1 functionality.
NOTE System firmware versions may change after the printing of this manual.
For further additional up-to-date information, please see the System
Firmware Matrix at the following URL:
http://docs.hp.com/hpux/hw/index.html#System%20Firmware