HP-UX 11i Version 1 Installation and Update Guide, June 2004

Using the update-ux Tool
Overview
Appendix C200
Overview
The update-ux command updates your system in this order:
1. Performs preparation steps including checking the root volume (see
“About update-ux” on page 201).
2. Calls swinstall to install software bundles from CD1. swinstall
does its Selection and Analysis processes on the software loaded from
the CD, then replaces the existing OS with 11i OS bundles and
default network drivers.
3. Prompts you after about an hour to replace CD1 with CD2 then calls
swinstall again to load any remaining software that you specified
in the update-ux command.
4. Reboots the system after all software has been loaded. These OS and
network driver bundles are loaded by default:
HPUXBase32 or HPUXBase64
HPUXBaseAux
HWEnable11i
BUNDLE11i
FEATURE11-11
FibrChanl-00 (64-bit OS only)
GigEther-00
GigEther-01
RAID-00 (64-bit OS only)
FDDI-00 (32-bit OS only)
(other networked drivers if needed)
OnlineDiag
perl
BaseVXVM
CDE-English (or appropriate language bundles)