HP-UX 11i Version 1 Installation and Update Guide, June 2004

Known Problems and Troubleshooting
Problems Configuring HP-UX 11i v1
Appendix B190
The following manuals are affected:
• HP A4800A PCI FWD SCSI Host Bus Adapter Service and User
Guide (A3725-96031, E0201), page 30
• HP A5149A PCI Ultra2 SCSI Host Bus Adapter Service and User
Guide (A5149-96003, E0201), page 31
• HP A5150A PCI Dual Port Ultra2 SCSI Host Bus Adapter Service
and User Guide (A5150-96002, E0201), page 35
• HP A5159A PCI Dual Port FWD SCSI Host Bus Adapter Service and
User Guide (A5159-96002), page 31
HP-UX Apache-based Web Server Requires LD Patch
to Start and Stop
IMPORTANT Due to an ld defect, you may encounter problems starting and stopping
HP-UX Apache-based Web Server (hpuxwsApache). At the time of this
writing, HP is unable to include a patch. To fix this problem, follow the
steps below:
To verify and install the required version of ld and libdld for the
HP-UX Apache-based Web Server:
Step 1. Verify that you are using ld and libdld version B.11.32 or higher. To
determine the version, enter the following command:
ld -V
Step 2. If the version number is less than B.11.32, install Patch PHSS_26560.
See “Installing Patches” on page 133 for more information on how to
install patches.
Step 3. As root, manually start HP Apache using the following command:
/opt/hpws/apache/bin/apachectl1 start
Additional
Documentation
For detailed configuration and installation instructions, see the following
HP Apache documentation in the paths listed below (or at
http://machinename/hp_docs/apache/document after the web server
is started):