HP-UX 11i Version 1 Installation and Update Guide, June 2004

Known Problems and Troubleshooting
Common Install and Update Error and Warning Messages
Appendix B 179
Common Install and Update Error and
Warning Messages
As an install or update progresses, you will see messages relating to the
progress being entered into the log file. These messages usually refer to
normal behavior. ERROR and WARNING messages, however, have the
following significance:
ERROR Indicates a serious problem, usually requiring action
from the user in order to proceed with an installation.
WARNING Indicates something out of the ordinary and may
require action.
If you see a message or experience unusual behavior, see the following
pages for likely solutions.
This section includes some update-ux error messages and typical
recovery actions.
Using Ignite-UX with HP-UX 11i v1 OEs and Patch
Bundles
In order for Ignite-UX to properly load patch bundles, the configuration
file for the install depot needs to be modified. The sd_software_list
definition needs to be removed from the bundle definitions for all patch
bundles in the depot. It is important that all the patch bundles in the
configuration file are modified to allow for patch supersession to work
properly.
The following patch bundles are supported for installation with the
desired HP-UX 11i v1 OE from a single depot source:
BUNDLE11i
HWEnable11i
FEATURE11-11
GOLDAPPS11i
GOLDBASE11i
If you have added any custom patch bundles to your install depot, the
sd_software_list definition for those bundles should be removed also.
With the sd_software_list definition removed, SD will use
autoselect_patches to resolve which patches should be installed.