HP-UX 11i Version 1 Installation and Update Guide, June 2004

Known Problems and Troubleshooting
Known Problems Discovered in this Release
Appendix B 163
• the anonymous IT Resource Center FTP site:
ftp://ftp.itrc.hp.com
Ignore Warning Message When Installing PHCO_29566
The patch PHCO_29566 and dependent patches enable attention buttons
(also known as Doorbells) for PCI OLAR operations on HP-UX 11i v1
servers. When you install this patch on systems with no OLAR
capability, it issues a warning message during the patch installation. If
you see the following warning message in the swagent.log file, you can
safely ignore it.
* Installing fileset "PHCO_29566.UX-CORE,r=1.0" (79 of 102).
Creating OLA/R device node at major 5...
Note that this system must have OLA/R capable hardware
and firmware for these features to be enabled.
WARNING: OLA/R capabilities not supported on this platform
WARNING: The "postinstall" script for "PHCO_29566" had a
warning (exit code "2"). The script location was
"/var/tmp/BAAa05060/catalog/PHCO_29566/pfiles/postinstall"
PHCO_29566 is found the December 2003 HWEnable11i (B.11.11.0312.4)
bundle.
xntpd Fails to Start on Reboot After Installing
GOLDQPK11i Patch Bundle
After installing the GOLDQPK11i patch bundle, xntpd may fail to start
after the initial reboot of the system.
How Do You Know
If This Affects You
In your syslog.log file, you may encounter a similar message:
Sep 23 14:46:23 <system_name> xntpd[1812]: tickadj = 625, tick =
10000,
tvu_maxslew = 6
1875
Sep 23 14:46:23 <system_name> xntpd[1812]: precision = 6 usec
Sep 23 14:46:23 <system_name> xntpd[1812]: bind() fd 4, family 2,
port 123,
addr 000000
00, in_classd=0 flags=1 fails: Address already in use