HP-UX 11i Version 1 Installation and Update Guide, June 2004

Updating to HP-UX 11i v1
How to Update to HP-UX 11i v1
Chapter 6 117
NOTE HP-UX 10.20 systems must use the pfs_mount (1M) command to mount
DVD media; HP-UX 11.0 or HP-UX 11i v1 systems can either install the
patches described in “Patching Your System to Read DVD Media” on
page 107, or use the pfs_mount command.
Step 7. Merge all products on the mounted CD/DVD to the target depot, for
example /update/update-depot:
•CD-ROM: swcopy -s /cdrom \* @ /update/update-depot
•DVD: swcopy -s /dvdrom \* @ /update/update-depot
Step 8. Unmount the CD or DVD from its directory
•CD-ROM: umount /cdrom
•DVD: umount /dvdrom
If you are updating to HP-UX 11i v1 using CD-ROM, follow steps
9 - 10; DVD users, continue to “Step 1: Install the update-ux
Command (Required Task!)” on page 118
Step 9. Insert the requested HP-UX 11i v1 CD. Wait for the drive’s busy light to
stop blinking.
Step 10. Repeat Steps 6 through 8 for the requested OE CDs and the Support
Plus CD.
The network depot is now ready to update your HP-UX 10.20 or 11.0
system to HP-UX 11i v1.