HP-UX 11i Version 1 Installation and Update Guide, June 2004

Cold Installing HP-UX 11i v1
Installing HP-UX 11i v1
Chapter 5100
Step 9. Whether using Guided Installation or Advanced Installation, proceed
through each screen to configure your system:
• Configurations: Lists the OS version (initially B.11.11).
• Environments: Specify desired OE from those available on the CD or
DVD. If your system is 32/64-bit capable, select the bundle for the OS
word-width you wish to install, 32 or 64 (page 34).
• Languages: Select the Languages... button to view CDE-languages
bundles to be loaded.
Global is set by default when installing on
workstations, resulting in all available CDE-language bundles being
installed.
Global (Non-CDE) is set when installing on servers to
indicate that a generic, CDE-language bundle will be installed.
• Additional Software: Select networking drivers and other applications
for your system (see “HP-UX 11i v1 Selectable Software Bundles” on
page 79, and “HP-UX 11i v1 Selectable Network Drivers” on
page 80).
IMPORTANT Do not de-select the HPUXBaseAux, HWEnable11i,
OnlineDiag, FEATURE11-11 or BUNDLE11i bundles. If in
doubt, leave the selections as default. Other software products may
be selectable, however, we recommend that you do not de-select any
products at this time. For more about Online Diagnostics, see
“Diagnostics Dependencies” on page 82 in Chapter 4.
TIP If you’re installing an Ignite-UX server, be sure to select the entire
Ignite-UX server product, B5725AA, thus installing the new
make_tape_recovery command (see the make_tape_recovery (1M)
manpage) command on your Ignite-UX server.
• At the end of the Guided Installation session, a screen allows you to
review any messages that Ignite-UX encountered. If there are any
errors, resolve them before continuing with the installation.