HP-UX 11i Version 1 Installation and Update Guide, June 2003

Install/Update System Requirements
Firmware Requirements
Chapter 3 55
Step 5. Enter q to leave this screen. Then press Enter at the next prompt, and
enter exit to exit the utility.
Step 6. If your system requires a firmware upgrade, proceed to “How to
Download Firmware Upgrades” on page 56
Using the Boot Display (this requires a reboot):
Step 1. As your system is booting up, interrupt the auto-boot sequence by
pressing any key when prompted. For example:
...
Primary boot path: 0/0/2/0.2
Alternate boot path: 0/0/2/0.2
Console path: 0/0/4/0.0
Keyboard path: 0/0/4/0.0
Processor is booting from first available device.
To discontinue, press any key with 10 seconds.
Step 2. You’ll see the boot Main Menu:
---Main Menu--------------------------------------------------
Command Description
------------ --------------
BOot [PRI|ALT|<path>] Boot from specified path
PAth [PRI|ALT] [<path>] Display or modify a path
SEArch [DIsplay|IPL] [<path>] Search for boot devices
COnfiguration menu Displays or sets boot values
INformation menu Displays hardware information
...
HElp [<menu>|<command>] Display help for menu or command
RESET Restart the system
Main Menu: Enter command or menu>
Enter: IN (for INformation)
Step 3. You’ll see the information menu:
---Information Menu-------------------------------------------
Command Description
------------ --------------
ALL Display all system information
BootINfo Display boot-related information
Cache Display cache information