HP-UX 11i Version 1 Installation and Update Guide, June 2003

Configuring Built-In PCI Networking
PCI 10/100Base-TX and 100Base-FX/9000
Appendix D202
Step 2. Configure the card using SAM:
a. Log in as root and verify that the card and its hardware path are
displayed by executing:
ioscan
b. Run the System Administration Manager: sam
c. Double click Networking and Communications.
d. Double click Network Interface Cards.
e. Highlight the PCI 10/100Base-TX or 100Base-FX card and choose
Configure from the Actions menu.
f. Fill in the form according to the instructions.
g. Click on the OK button to activate the card. Then select Exit from the
File menu until you exit SAM.
Step 3. Verify the installation:
a. Obtain the PPA (on HP-UX 10.20, it is the NMIDnumber) and the
station address of your card by executing:
lanscan
b. To verify that no errors have occurred during installation, enter:
linkloop -i PPA_number station_address
If there is a problem, you can obtain error messages by entering:
dmesg
c. Verify connectivity with a remote system by entering:
ping remote_IP_address and netstat -in
d. PCI 10/100Base-TX/9000 or 100Base-FX installation is complete
when you have successfully ran these two commands:
linkloop
ping