HP-UX 11i Version 1 Installation and Update Guide, June 2003

Known Problems and Troubleshooting
Known Problems Discovered in this Release
Appendix B160
What To Do Use the following commands to modify the /etc/inittab file in your
Ignite-UX post-config script:
echo ‘vol1::sysinit:/sbin/init.d/vxvm-sysboot \
</dev/console >/dev/console 2>&1 ##vxvm’ >>//etc/inittab
followed by:
echo ‘vol2::sysinit:/sbin/init.d/vxvm-startup start \
</dev/console >/dev/console 2>&1 ##vxvm’ >>/etc/inittab
Kernel Build Warnings For krm Module During
Cold-Install or Update
During a cold-install or update, you may encounter the a warning
message in either /var/opt/ignite/local/install.log or
/var/adm/sw/update-ux.log indicating that debug information may be
corrupted. The warning may appear as follows:
Generating module: krm...
/usr/lbin/sw/bin/mkdir -p /stand/build
Compiling /stand/build/conf.c...
Loading the kernel...
(Warning) Optimizing ADDILs in the presence of the debug
information. Debug information may be corrupted (1594)
Generating kernel symbol table...
What To Do: This warning has been fixed with patch PHKL_27447, included in the
June 2003 Gold Quality Pack Bundle. To avoid seeing this warning,
make sure to select the Gold Quality Pack bundle for installation when
you begin cold-installing or updating your system.
Boot Error Messages Appear After Updating from
HP-UX 11.0 (with MirrorDisk/UX Installed) to HP-UX
11i v1 TCOE
If you are updating to HP-UX 11i v1 TCOE from HP-UX 11.0 with
MirrorDisk/UX installed, the following error message may appear during
the boot process: