HP-UX 11i Version 1 Installation and Update Guide, June 2003

Booting HP Servers and Workstations
Halting the Autoboot Process
Appendix A148
Halting the Autoboot Process
1. Make sure any external devices connected to the target system are
switched ON.
2. Switch ON the target computer or cycle power.
3. Insert the install media into the drive. At the Stop Autoboot
message:
• Workstations: Press and hold down Esc.
•Servers: Press and hold down Esc or any other key.
4. See the appropriate following section for your system’s boot process.
If you need help during the boot process, enter: help