HP-UX 11i Version 1 Installation and Update Guide, June 2003

Updating to HP-UX 11i v1
How to Update to HP-UX 11i v1
Chapter 6 117
DVD: mount /dev/dsk/c1t2d0 /dvdrom
Step 7. Merge all products on the mounted CD/DVD to the target depot, for
example /update/update-depot:
CD-ROM: swcopy -s /cdrom \* @ /update/update-depot
DVD: swcopy -s /dvdrom \* @ /update/update-depot
Step 8. Unmount the CD or DVD from its directory
CD-ROM: umount /cdrom
DVD: umount /dvdrom
If you are updating to HP-UX 11i v1 using CD-ROM, follow steps
9 - 10; DVD users, continue to “Step 1: Install the update-ux
Command (Required Task!)” on page 117
Step 9. Insert the requested HP-UX 11i v1 CD. Wait for the drive’s busy light to
stop blinking.
Step 10. Repeat Steps 6 through 8 for the requested OE CDs and the Support
Plus CD.
The network depot is now ready to update your HP-UX 10.20 or 11.0
system to HP-UX 11i v1.
Step 1: Install the update-ux Command (Required
Task!)
Unless you are already running a previous version of 11i, you must
install the update-ux command to update to 11i from CDs. Follow these
steps:
Step 1. Insert the HP-UX 11i v1 CD1 or DVD and wait for the drive’s busy light
to stop blinking.
Step 2. Find the CD-ROM or DVD-ROM device file name:
ioscan -f -C disk | more
/dev/dsk/c1t2d0 is a typical CD-ROM device name.
Step 3. Create the directory under root(/):
CD-ROM: mkdir /cdrom