HP-UX 11i Version 1 Installation and Update Guide, June 2003

Cold Installing HP-UX 11i v1
Installing HP-UX 11i v1
Chapter 5 101
• Additional Software: Select networking drivers and other applications
for your system (see “HP-UX 11i v1 Selectable Software Bundles” on
page 78, and “HP-UX 11i v1 Selectable Network Drivers” on page
79).
IMPORTANT Do not de-select the HPUXBaseAux, HWEnable11i,
OnlineDiag, FEATURE11-11 or BUNDLE11i bundles. If in
doubt, leave the selections as default. Other software products may
be selectable, however, we recommend that you do not de-select any
products at this time. For more about Online Diagnostics, see
“Diagnostics Dependencies” on page 82 in Chapter 4.
TIP If you’re installing an Ignite-UX server, be sure to select the entire
Ignite-UX server product, B5725AA, thus installing the new
make_tape_recovery command (see the make_tape_recovery (1M)
manpage) command on your Ignite-UX server.
• At the end of the Guided Installation session, a screen allows you to
review any messages that Ignite-UX encountered. If there are any
errors, resolve them before continuing with the installation.
NOTE Ignore any message stating that /var needs to be larger than
available to hold a dump file. /var typically only needs to be set to
50-100% as large as the current memory to handle dump files.
Step 10. When finished configuring your installation:
•With Guided Installation, select: Finish
•With Advanced Installation, select GO! (at the bottom of any tab). A
confirmation screen lists the disks that will be written to during
installation and a log of any warnings or errors encountered. You
have the chance to
Cancel at this time. If you cancel, you return to
the previous configuration screen.