HP-UX 11i Version 1 Installation and Update Guide, December 2004

15
• Chapter 6, “Updating to HP-UX 11i v1,” on page 91
Use this chapter to learn how to update your system to HP-UX 11i v1
using the update-ux command. Several examples are provided to
assist you with your update scenario.
• Chapter 7, “Installing HP Applications and Patches,” on page 113
Use this chapter to learn how to update applications on your system
that are not installed or updated with HP-UX 11i v1 Operating
Environments.
• Chapter 8, “Verifying System Install or Update,” on page 119
Use this chapter to learn how to verify a successful install or update
to HP-UX 11i v1.
• Appendix A, “Booting HP Servers and Workstations,” on page 125
Use this appendix to learn about booting various HP servers and
workstations using the built-in Boot ROM firmware interface.
• Appendix B, “Known Problems and Troubleshooting,” on page 135
Use this appendix to learn about the known problems and
troubleshooting steps for the install and update.
• Appendix C, “HP-UX 11i v1 Software Bundles,” on page 177
Use this appendix to learn about the Operating Environments (OEs)
and media contents.
• Appendix D, “Configuring Built-In PCI Networking,” on page 189
Use this appendix to learn how to configure built-in (or core) PCI
networking cards in HP Servers and Workstations.
• Appendix E, “Controlling Memory Utilization of VxFS 3.5 on HP-UX
11i v1,” on page 197
Use this appendix to learn about the effect of two VxFS tunables,
vx_ninode and vxfs_bc_bufhwm, on system memory consumption
and learn about the guidelines on setting them for machines with
relatively low RAM.