HP-UX 11i Version 1 Installation and Update Guide, December 2003

Install/Update System Requirements
Firmware Requirements
Chapter 3 61
...
34 160 CPU (5c4)
35 166 CPU (5c4)
Select any one of the processors (CPU) to use in the next step.
Step 3. Use the CPU device number as input to the sel dev command to request
information on that processor. For example:
cstm>sel dev 34; info
-- Updating Map --
Updating Map...
Step 4. Use the information log command (il) to find the firmware version
number:
cstm>il
-- Converting a (5060) byte raw log file to text. --
... (output lines are omitted)
-- Information Tool Log for CPU on path 160 --
Log creation time: Wed May 10 10:21:53 2000
Hardware path: 160
...(output lines are omitted)
Firmware Revision: 40.14
Step 5. Enter q to leave this screen. Then press Enter at the next prompt, and
enter exit to exit the utility.
Step 6. If your system requires a firmware upgrade, proceed to “How to
Download Firmware Upgrades” on page 63
Using the Boot Display (this requires a reboot):
Step 1. As your system is booting up, interrupt the auto-boot sequence by
pressing any key when prompted. For example:
...
Primary boot path: 0/0/2/0.2
Alternate boot path: 0/0/2/0.2
Console path: 0/0/4/0.0
Keyboard path: 0/0/4/0.0
Processor is booting from first available device.
To discontinue, press any key with 10 seconds.