HP-UX 11i Version 1 Installation and Update Guide, December 2003

Install/Update System Requirements
System Requirements
Chapter 352
OLA/R Support
Online addition and replacement (OLA/R) is not supported on HP-UX 11i
v1 with the A5801A HIPPI PCI I/O adapter. For rp7410 servers: slots
0-0-0-1 and 0-0-1-8 are dedicated to the LAN/SCSI card portion of the
MP Core I/O, and do not support OLA/R if cards in these slots are
considered "critical resources". For more about OLA/R support, see
“SCSI PCI Restrictions for OLA/R” on page 199” in Appendix B and this
web site:
http://itrc.hp.com
HP 3D Graphics No Longer Supported pre PA-RISC
2.0 Systems
IMPORTANT As of the September 2002 HP-UX 11i v1 release, HP 3D Graphics are no
longer supported on PA-RISC systems older than version 2.0. If you have
an older PA-RISC workstation and need 3D Graphics, HP recommends
that you do not install or update to the December 2003 release of
the Technical Computing (TCOE) or Minimal Computing Operating
Environments (MCOE).
Previous releases of HP-UX 11i v1 still support PA-RISC 2.0 and older
systems. If you have any questions about your particular situation,
please contact your local HP Country Response Center.
How to Determine Your System’s PA-RISC Version
With the System Administration Manager (SAM), select: Performance
Monitors > System Properties. Your PA-RISC version will appear next
to the CPU Version line:
PA 8600-8600 CPU 3.1
If this lines reads less than 8000, then your CPU version is older than
version 2.0