HP-UX 11i Version 1 Installation and Update Guide, December 2003

Known Problems and Troubleshooting
Update Known Problems
Appendix B 185
kill: 616: The specified process does not exist.
NOTE: You may need to restart SNMP agents.
The error is caused by the kill command trying to end a process that is
already terminated. When the OVSNMPAgent.MASTER fileset is installed,
it invokes a kill command to terminate any existing SNMP agents. The
next fileset, OVSNMPAgent.SUBAGT-HPUNIX, also attempts to terminate
any SNMP Agent processes.
How Do You Know
if this Affects You
If you are migrating from HP-UX 10.20 or 11.0 to HP-UX 11i v1, you may
receive this error message during the installation of the OpenView
SNMP bundle.
What To Do You can safely ignore this message.
“Initialize of the ITO Control Agent failed” Error
During update-ux Session
Beginning in June 2002, the ITO-SE single system event management
component was removed from the GlancePlus Pak 2000 product.
How Do You Know
If This Affects
You?
If you are updating from HP-UX 10.20 or 11.0 and you have a version of
GlancePlus Pak 2000 released prior to June 2002, update-ux will try to
remove the ITO-SE component prior to updating to a newer GlancePlus
Pak. You may encounter the following error when update-ux removes
the file sets belonging to the ITO-SE component:
* Beginning the Unconfigure Execution Phase.
* Filesets: 3
* Files: 163
* Kbytes: 15427
* Running remove setup command /usr/lbin/sw/remove_setup.
Error opcctla (Control Agent)(14791) : Initialize of the ITO
Control Agent failed. (OpC30-1036)
Can't lookup servers: Communications failure (dce / rpc).
(OpC20-108)
Can't lookup servers: Communications failure (dce / rpc).
(OpC20-108)
Stopping all ITO Agent processes... (OpC30-1192)
/usr/bin/ps: couldn't get console device alias
/usr/bin/ps: not enough memory for hash table