HP-UX 11i Version 1 Installation and Update Guide, December 2003

Known Problems and Troubleshooting
Update Known Problems
Appendix B 179
Update Known Problems
DMI/SCR Become Unbundled After Update
After updating to the September 2003 release (or later) of HP-UX 11i v1,
you may encounter a warning after running the swlist command
indicating that DMI/SCR (B6816AA) was unbundled during the update:
#
# Product(s) not contained in a Bundle:
#
DMI B.11.11.30 Desktop Management Interface for HP-UX
SCR B.11.11.30 System Configuration Repository
How Do You Know
If This Affects
You?
You will encounter this warning if DMI/SCR (B6816AA) was installed
prior to updating.
What To Do DMI/SCR will continue to work after the update. If you plan to continue
using DMI/SCR, HP recommends that you download the latest version of
DMI from http://software.hp.com. Starting with the September 2003
release, DMI will no longer be shipped as part of the operating
environments. Instead, it will be available and supported as a web-only
product.
Unsupported Upgrade of ServiceControl Manager
Causes SCR Error During Update
While updating a 10.20 system to either the Foundation, Enterprise or
Mission Critical operating environment, you may encounter the
following error messages in swagent.log appearing to affect SCR:
ERROR: [300076] Cannot delete the definition for product "SCR" from
the target "/". The product is not empty, it still contains
filesets.
These error messages are caused by an unsupported upgrade of
ServiceControl Manager 3.0 from a version of SCM earlier than version
2.5. SCM 3.0 only supports upgrades from version 2.5 or higher.
Because this is an unsupported upgrade path, no changes will be made to
either SCR or ServiceControl Manager.