HP-UX 11i Version 1 Installation and Update Guide, December 2003

Updating to HP-UX 11i v1
How to Update to HP-UX 11i v1
Chapter 6 131
Step 2: Using update-ux to Update to HP-UX 11i v1
After you have installed update-ux on the target system (see “Step 1:
Install the update-ux Command (Required Task!)” on page 128) and,
optionally, created an update depot containing all software to be
installed, (see “Optional Step: Create a Network Depot” on page 127),
you can now proceed to update your target system. Use the following
syntax to run update-ux:
update-ux -s source_location [-?] [-a 32|64] [-n|-y] [-i]
[-x option=value] [sw_spec]
NOTE For more information about update-ux syntax, see “update-ux Syntax”
on page 212