HP-UX 11i Version 1 Installation and Update Guide, December 2003

Updating to HP-UX 11i v1
Problems Reading HP-UX 11i v1 DVD Media
Chapter 6118
For Systems Currently Running HP-UX 11.0:
• PHCO_26450 (11.00 Y2k; Rock Ridge extension for ISO-9660)
• PHKL_28060 (11.00 Add Rock Ridge extension to mount_cdfs (1M))
• PHKL_26449 (11.00 Rock Ridge extension for ISO-9660)
For Systems Currently Running HP-UX 10.20:
There are no patches available. Use the pfs_mount (1M) command to
mount the DVD and update to HP-UX 11i v1, see “Using pfs_mount to
Mount a DVD” on page 118.
To determine if your system already has the listed patches installed, run
the following:
/usr/sbin/swlist -l patch | grep <patch_name>
where <patch_name> is one of the patches listed above for your operating
system version. If nothing is printed to standard output, you need to
install the patches from one of the following sources:
•the GOLDBase11i bundle on the Support Plus CD (June 2003 or later)
for HP-UX 11i v1
•the QPK1100 bundle on the Support Plus CD (September 2003 or
later) for HP-UX 11.0
• the IT Resource Center website (requires login):
http://itrc.hp.com
• the anonymous IT Resource Center FTP site:
ftp://ftp.itrc.hp.com
Using pfs_mount to Mount a DVD
You can use the pfs_mount (1M) command to mount a DVD on any
supported HP-UX system updating to HP-UX 11i v1. For HP-UX 10.20,
this is the only supported method for reading DVD media with large
volumes of data.
On HP-UX 11.0 and HP-UX 11i v1 systems, you can alternately install
patches to read DVD media correctly (see “Patching Your System to Read
DVD Media” on page 117). If you have already installed the patches, you
do not need to use the pfs_mount command to mount the DVD media.