HP-UX 11i v1 Installation and Update Guide, September 2005

Known Problems and Troubleshooting
Common Install and Update Error and Warning Messages
Appendix B154
Warning Displays
WARNING: There were errors installing from the first
depot. See the /var/adm/sw/swagent.log for details.
WARNING: Continuing could cause the OS update to fail
Do you want to continue ? (y/n)
Press y to continue the update. Afterward, review
/var/adm/sw/swagent.log.
Disk Space Usage
Error
To perform this OS update, it is required that the
xxx partition have at least yyy KB of free space and
it currently has zzz KB of free space
Reconfigure your disk per the minimum recommendations in
the message. Then run the update-ux command again.
swinstall Analysis
Error
The analysis phase failed while installing from the
first depot. See the /var/adm/sw/swagent.log for
details.
The swinstall analysis on software from HP-UX 11i v1 CD1
failed and update-ux quit. Correct the indicated problem and
run the command again.
Post-update swverify
Error
After updating your system to an HP-UX 11i v1 OE, run
swverify to ensure that all application software previously
on your system is still compatible with the new OS. If you get
an error like this:
The product "xyz,l=/,r=B.xx.xx" is not compatible
with this system’s architecture or operating system.
The indicated software (xyz) has not been updated to HP-UX
11i. To update the software, mount the HP-UX 11i v1
Applications CD that contains the software and install the
new version using the swinstall command. For more details,
see Chapter 7.
Table B-3 Common Install and Update Error and Warning Messages
Problem Description/Action