HP-UX 11i v1 Installation and Update Guide, September 2005

Known Problems and Troubleshooting
Known Update Problems
Appendix B140
Known Update Problems
Table B-2 describes update problems known to occur in the HP-UX 11i v1
release.
Table B-2 Known Update Problems
Problem Description/Action
Ignore error message:
Pay Per Use Failed
During upgrade of your HP-UX 11i v1 (B.11.11) system, the
following error message is in the rc.log:
/sbin/rc[41]: /sbin/rc2.d/S700ppu: not found.
"/sbin/rc2.d/S700ppu start" FAILED
Or you may see this message in the console log:
Initialize Pay Per Use............ Failed
These messages are extraneous, do not cause any ill effects,
and you can ignore them.
DMI/SCR Become
Unbundled After
Update
After updating to the September 2003 release (or later) of
HP-UX 11i v1, you may encounter a warning after running
the swlist command indicating that DMI/SCR (B6816AA)
was unbundled during the update:
#
# Product(s) not contained in a Bundle:
#
DMI B.11.11.30 Desktop Management
Interface for HP-UX
SCR B.11.11.30 System
Configuration Repository
You will encounter this warning if DMI/SCR (B6816AA) was
installed prior to updating.
DMI/SCR will continue to work after the update. If you plan
to continue using DMI/SCR, HP recommends that you
download the latest version of DMI from
http://www.hp.com/go/softwaredepot
Starting with the September 2003 release, DMI will no longer
be shipped as part of the Operating Environments. Instead, it
will be available and supported as a web-only product.