HP-UX 11i v1 Installation and Update Guide, September 2005

Updating to HP-UX 11i v1
Updating to HP-UX 11i v1
Chapter 6104
Updating to HP-UX 11i v1 OS (No OE Installed)
IMPORTANT If you already have an Operating Environment installed on your system,
you cannot use this scenario. Instead, use “Updating to HP-UX 11i v1 OS
(OE Installed)” on page 103. Attempting this scenario when you already
have an Operating Environment installed will cause update-ux to fail.
NOTE HP strongly recommends that you update your system with an
Operating Environment to provide you with an integrated and tested set
of supporting software and applications.
If you do not specify an OE bundle, update-ux only installs the OS,
networking, diagnostic, and CDE bundles listed in Appendix C, “HP-UX
11i v1 Software Bundles,” on page 175. Any additional software bundles
associated with an OE are not installed.
For example, to update the HP-UX 11i v1 OS, insert the HP-UX 11i v1
DVD in the local mounted drive and enter the following command:
/usr/sbin/update-ux -s /dvdrom
Adding or Upgrading an OE
To install an OE on an HP-UX 11i v1 system not containing an OE, or to
upgrade HP-UX 11i v1 to higher-level OE (for example, HP-UX 11i v1
Foundation OE to HP-UX 11i v1 Enterprise OE), insert the HP-UX 11i
v1 DVD and specify the new OE using the update-ux command.
For example, to add the HP-UX 11i v1 Enterprise OE, enter:
/usr/sbin/update-ux -s /dvdrom HPUX11i-OE-Ent
When the update is complete, the original OE bundle wrapper (if one
existed) is removed and replaced with the new bundle wrapper.