HP-UX 11i v1 Installation and Update Guide, September 2005

Updating to HP-UX 11i v1
Updating to HP-UX 11i v1
Chapter 6102
Examples: Using update-ux to Update Your System
Your system configuration and your planning determine how you use
update-ux. This section provides some scenarios and examples of how
you might use update-ux to update your system:
• “Updating to HP-UX 11i v1 OS (OE Installed)” on page 103 explains
how to update to HP-UX 11i v1 with an Operating Environment.
• “Updating to HP-UX 11i v1 OS (No OE Installed)” on page 104
describes how to update the HP-UX 11i v1 OS without an Operating
Environment.
• “Adding or Upgrading an OE” on page 104 explains how to update
your system by either adding or upgrading the Operating
Environment on your system.
• “Downgrading an OE” on page 105 explains how to move your
system from an advanced Operating Environment to a smaller
Operating Environment.
• “Updating from a Network Depot” on page 105 explains how to
update your system from a server on the network.
• “Updating Selectable Software” on page 106 explains how to update
your system with selectable software bundles.
• “Updating Using Interactive Software Selection” on page 106
explains how to use the interactive option to manually select the
software you want to update.
• “Updating to a 64-bit OS” on page 107 shows you how to move a
32-bit system to a 64-bit OS.
• “Update Using match_target” on page 107 explains how to update
your system using the match_target option.