HP-UX 11i v1 Installation and Update Guide, December 2006

Known Problems and Troubleshooting
Common Install and Update Error and Warning Messages
Appendix B158
EISA 100BT Warning
Message
When you remove an EISA 100BT product from a system or
update a system having EISA 100BT to any later releases of
HP-UX, you may find the following message in the
/var/adm/sw/swagent.log file:
Running remove setup command
/usr/lbin/sw/remove_setup.
/dev/diag/ether* not found.
This behavior is present in HP-UX 10.20 to HP-UX 11i
(B.11.11) versions of this product. Presence or absence of this
file on a system will not have any impact on this product. You
may safely ignore this message.
Using Ignite-UX with
HP-UX 11i v1 OEs and
Patch Bundles
In order for Ignite-UX to properly load patch bundles, the
configuration file for the install depot needs to be modified.
The sd_software_list definition needs to be removed from
the bundle definitions for all patch bundles in the depot. It is
important that all the patch bundles in the configuration file
are modified to allow for patch supersession to work
properly.
The following patch bundles are supported for installation
with the desired HP-UX 11i v1 OE from a single depot source:
BUNDLE11i
HWEnable11i
FEATURE11-11
GOLDAPPS11i
GOLDBASE11i
If you have added any custom patch bundles to your install
depot, the sd_software_list definition for those bundles
should be removed also. With the sd_software_list
definition removed, SD will use autoselect_patches to
resolve which patches should be installed.
Table B-3 Common Install and Update Error and Warning Messages
Problem Description/Action