HP-UX 11i September 2005 Release Notes

Workstation- and Server-Specific Information
Networking and Mass Storage Drivers
Chapter 4
70
Enabling ISEE
ISEE is installed in a disabled state. To enable the client, complete the following steps:
1. In the file /etc/rc.config.d/hpservices.conf change the value of START_TUNER
from
0 to 1
2. In the file /etc/rc.config.d/rstemsListener change the value of RST_LISTENER
from
0 to 1
3. Execute /sbin/init.d/hpservices start
4. Execute /sbin/init.d/rstemsListener start
Configuring ISEE
The ISEE configuration process is documented in the HP Instant Support Enterprise
Edition Client Installation and Upgrade Guide.
The HP Runner availability component is installed with ISEE but is not active. To
enable HP Runner, run the following command as root:
at -f /opt/runner/bin/retry now
Performance
There is neither a performance improvement nor any known degradation in
performance.
Documentation
Information about ISEE, including the HP Instant Support Enterprise Edition Client
Installation and Upgrade Guide, is available at http://www.hp.com/learn/isee.
For a complete list of ISEE-supported operating systems and hardware devices, please
view the ISEE supported products Web page at
http://www.hp.com/hps/hardware/hw_products.html.
Obsolescence
Not applicable.
Networking and Mass Storage Drivers
HP-UX 11i v1 includes drivers for networking and mass storage adapter cards. The
drivers are described in the following sections:
• Always-Installed Networking Drivers (see page 71)
• Selectable Networking Drivers (see page 75)
• Always-Installed Mass Storage Drivers (see page 77)